Pad Cell Generator: Difference between revisions

From LibreSilicon
Jump to navigation Jump to search
No edit summary
No edit summary
Line 2: Line 2:


The Pad Cell Generator has the task of generating a [[Pad Cell]] for generating a pad frame for taping out a circuit with any given set of design rules for any given process.
The Pad Cell Generator has the task of generating a [[Pad Cell]] for generating a pad frame for taping out a circuit with any given set of design rules for any given process.
A typical pad cell consists of driver logic, ESD protection and a bonding pad, which essentially just is a "large" metal square, big enough to fit a bonding ball needed to attach the bonding wire or solder it to a PCB (flip chip bonding) or onto another carrier substrate chip (chiplet assembly)[[File:Padcell.png|Pad Cell in Magic editor|none|frame]]
== Driver Logic ==
This part of the pad cell is purely combinatorial, and controls based on its pins on the logic side where it's interfacing to the internal logic, what modes should be configured.
For instance, whether the output is enabled, in which case it would either drive current through its driver circuit or pull down to ground in case pull down mode is being set from the internal logic.
It can also be configured for high impedance input, in case OE is disabled.
Various additional functions can be implemented, like for instance impedance and termination resistor calibration in case it's part of a DRAM or PCIe PHY.
In short, the driver logic configures the actual physical properties of the pad depending on what the internal logic tells it to do:
* Set transistors to either drive from the VCC rail to ground or switch towards ground
* Setting whether the driver should be active at all (Output Enable)
* Provide a state engine or other means for configuring the termination resistance to ground.
== Driver circuit ==
Internally, transistors of a logic circuit only can drive a few micro amperes of current and are unable to survive driving a load like an LED.
In order to make a chip do something useful driver circuits need to be implemented which can provide the power needed for actually driving loads like making an LED blink or driving a small DC motor.
This is being done in the driver circuit through [[Fingered Transistors]] which turn the low power logic states at its inputs into a state which is useful to the outside world.
== ESD protection ==
lorem ipsum
== Bonding pad ==

Revision as of 10:49, 30 November 2024

The LibreSilicon Pad Cell Generator is an extension of the Standard Logic Cell Library generator, which besides the driver logic also dynamically generates the mixed signal parts needed for over current and static discharge protection and providing the currents needed for doing useful things with an actual physical chip, like driving an LED or a small motor.

The Pad Cell Generator has the task of generating a Pad Cell for generating a pad frame for taping out a circuit with any given set of design rules for any given process.

Retrieved from "https://wiki.libresilicon.com/index.php?title=Pad_Cell_Generator&oldid=439"